Parts required
Coat hanger wire approx 200 mm long
4 mm nail or screw
3mm elastic cord
1. Firstly in the middle of the wire bend a full 360 degree loop around the nail.
- Paper Towel Holder1.JPG (23.33 KiB) Viewed 5003 times
- Paper Towel Holder2.JPG (17.76 KiB) Viewed 5003 times
2. Then about 20mm from the loop on the short end of the wire put a 180 degree bend on the opposite side to the loop. Trim to a length of about 15mm and smooth end.
- Paper Towel Holder3.JPG (16.32 KiB) Viewed 5003 times
3. Measure about 50mm from the loop and put a 180 degree bend on the same side as the loop. Trim to a length of about 15mm and smooth end.
- Paper Towel Holder4.JPG (15.88 KiB) Viewed 5003 times
4. Straighten ends and loop so they are all in alignment.
5. About 15mm from long end bend at 90 degrees to the loop.
- Paper Towel Holder6.JPG (17.42 KiB) Viewed 5003 times
6. Repeat steps 1 to 4 and at step 5 make the bend 90 degrees in the opposite direction so you have one left hand and one right hand.
- Paper Towel Holder7.JPG (16.13 KiB) Viewed 5003 times
7. Place 3mm elastic cord through loops and tie a knot at each end. The length will be dependant on what you want to hold.
- Paper Towel Holder8.JPG (14.7 KiB) Viewed 5003 times
8. To mount it; hook the short end over the plastic trim adjacent to a window. I have a paper towel roll permanently mounted on the tailgate and another that I use on trips to carry extra paper towel and toilet roll mounted on one of the rear side windows.
- Paper Towel Holder9.JPG (15.89 KiB) Viewed 5003 times
- Paper Towel Holder10.JPG (15.11 KiB) Viewed 5003 times
Increase the tension as the paper towel gets used up by pulling one end through the open hook so the knot is held by the hook and then the other.
- Paper Towel Holder10.JPG (15.11 KiB) Viewed 5003 times